Installation Guide

17
Top Frames and [Q2]
[S3] x 8
[
S4] x 8
DOOR
COMMON MISTAKE: [Q2]
A [Q2] has four screw holes on each of its ends. In step [2.3], only
screw holes No. 2 and No. 3 of each [Q2] are used. No. 1 and No. 4
will be used in following steps. So far this is the same as step [2.1]
Now pay special attention to screw hole No. 3. Bend [Q2] a little bit
and you will see that there is only one screw hole on [B1] [B2] [B3]
[B4]. It is called a frame screw hole and it matches the screw hole
No. 3.
So, when nailing [Q2] to [B1] [B2] [B3] [B4], use screw hole No.3 first.
This is the only correct layout of [B4]+[B5] and [B2]+[B1]. [B4]+[B5] is at the [DOOR] side, while [B2]+[B1] is at the backwa
ll
side.
[B4]
[Q2]
[B5]
[Q2]
[B1]
[B2]
RARE MISTAKE
[B1]+[B2][B4]+[B5]
Right Wall
Notice
Pay special attention to the orientation of
[BL1]. After this step is done, [BL1] should lie
horizontally, not vertically.