Installation Guide

17
GENERAL RULES
GENERAL RULES: Single Wall Panel Nailing
Read COMMON MISTAKE: Screw Holes on the Outer Base(D1+D2) again.
As stated before, a wall panel has no assigned top/bottom end. It’s up to
you to decide which end is the top or bottom. Once you have made the
decision, follow the rules below.
1. Start from the screw holes at the bottom end.
2. At each end, start from the peripheral screw holes and move to the
screw hole in the middle.
Take the [Q1] on the left for example, ①~⑩ is the correct order of xing
screw holes.
These rules might sound arbitrary but they are necessary.
Step [2.4] is quite special because all the screw holes at the bottom end
have already been xed.