Installation Guide
11
GENERAL RULES
Wall Panels
Remove the protective lms rst
[Q2] x 3 [Q3] x 2 [Q1] x 2 [Q4] x 2
These are the wall panels you will be using.
Wall Panels, except for [Q3]/[Q4], are symmetrical,
meaning they don’t have assigned top/bottom, or left/
right. But they do have exterior and interior, with the
exterior’s color being the color of the shed and the inte-
rior’s color a universal light grey.
[Q3] and [Q4] do have a dierence between its left and
right, but no dierence between its top and bottom.
Starting from Step 2.1, you will be using [S3] together
with [S4]. [S4] is useful for protecting the punched screw
holes from getting rusty. So use them.
[S4] [S3]
COMMON MISTAKE: Screw Holes on the Outer Base(D1+D2)
There are screw holes on both the base frames and the wall panels. It is self-explanatory that you need to nail the wall panels to the base frames
using the screws ([S3]+[S4]). However, since the base frames are made of aluminum, a soft yet ductile metal, you can easily drill the screws into
the base frames without the screws going into the correct screw holes. So, when assembling wall panels, bend the panels a little bit and see to it
that the screw is going into the screw hole.
Screw Hole