Installation & Assembly

FILTRATION FAUCET INSTALLATION INSTRUCTIONS, page 3 of 4
Drill 1-3/8” hole in countertop.
(Maximum counter thickness is 2”)
Center the base plate with built-in
O-ring over the mounting hole on
the top of the countertop. Center the
faucet body on the base plate.
If desired, apply a thin bead of silicone
seal under the base plate for added
sealing.
DO NOT USE PLUMBERS’ PUTTY
For Hot Only Faucet: Place faucet
handle in desired position.
Fasten the faucet from under the
countertop by rst sliding the rubber
washer, then the metal washer onto
the faucet stem.
Make sure to place the 3 screws on
the metal washer through the match-
ing holes of the rubber washer and
slide both washers up to the bottom of
the countertop.
HOT ONLY and HOT/COLD FILTRATION FAUCET W/ BTI AQUA-SOLUTIONS DIGITAL INSTANT HOT WATER DISPENSER
ITEMS: H2100, H2200, H2400, HC2100, HC2200, HC2400, HT4105
1
2
3
Hoses are attached to faucet body as
shown in diagram.
A - Blue Label Cold Water-In Hose
B - Faucet Stem
C - Hot Only Faucet, Hot Handle
D - Black Label Pressure Tank Hose
E - Hot & Cold Faucet, Cold Handle
F - Blue Label Cold Water-In Hose
G - Faucet Stem
H - Black Label Pressure Tank Hose
I - Hot & Cold Faucet, Hot Handle
A
C
D
E
F
G
H
I
B
4
Place a metal pinch-clamp on one
end of the clear hose and attach the
clear hose to faucet stem end.
Secure with pinch-clamp.
5
Attach the braided blue label cold-
water-in hose to cold-water supply
line.
Use plumbers’ tape on the outside
threads to provide a good seal.
6
Thread the mounting nut to the top
of the faucet stem and hand tighten.
Once the faucet is secure, tighten the
3 screws against the underside of the
countertop. This will prevent the faucet
from moving/spinning.
7