User's Manual
Table Of Contents
- 1 Introduction
- 2 Safety
- 3 System Overview and Unit Description
- 3.1 System Overview
- 3.2 Host Unit Description
- 3.3 Remote Node Description
- 4 System Installation
- 4.1 Unpacking and Inspection
- 4.2 Installation Preparation
- 4.3 Host Unit Installation
- 4.4 Remote Node Installation
- 4.5 Installation Final Inspection
- 4.6 System Test
- 5.1 Accessing EMS Local GUI
- 5.2 Navigating the EMS Local GUI
- 5.3 Installation & Configuration
- 5.4 System Tuning
- 5.5 Monitoring and Alarms
- 5.6 System Upgrade
- 6 Maintenance
- 7 Terms, Acronyms & Abbreviations
- 8 Packing List
mBSC2500U-005-RUCM11
MBSC2500U-005-RUCM11 April 15, 2013
Page 29
Figure 22Host Unit Grounding Stud
Figure 23 Grounded Host Unit
4. Tighten the screw, making sure the cable is securely connected before moving to the next phase of
the installation.
4.3.2.2 Coaxial Cable Connections
The RF interface between the Host Unit and the BTS (or POI) is supported through Tx/Rx QMA female
connectors mounted on the Host Unit front panel.
The Host Unit should be mounted as close as possible to the BTS to minimize RF cable losses. Use the