User's Manual
Table Of Contents
- 1 Introduction
- 2 Safety
- 3 System Overview and Unit Description
- 3.1 System Overview
- 3.2 Host Unit Description
- 3.3 Remote Node Description
- 4 System Installation
- 4.1 Unpacking and Inspection
- 4.2 Installation Preparation
- 4.3 Host Unit Installation
- 4.4 Remote Node Installation
- 4.5 Installation Final Inspection
- 4.6 System Test
- 5.1 Accessing EMS Local GUI
- 5.2 Navigating the EMS Local GUI
- 5.3 Installation & Configuration
- 5.4 System Tuning
- 5.5 Monitoring and Alarms
- 5.6 System Upgrade
- 6 Maintenance
- 7 Terms, Acronyms & Abbreviations
- 8 Packing List
mBSC2500L-005-RUCM11
MBSC2500L-005-RUCM11 April 15, 2013
Page 31
Figure 25Single Mode Patch Cord(E2000/APC)
Figure 26E2000 Fiber Optic Port on Host Unit FIU
4. Route the patch cords from the Host Unit to the Remote Node.
5. Connect optical fiber to the Remote Node RTM fiber port.
4.3.2.4 DC Power Connection
The DC power interface of the Host Unit is provided by a 2-wire termination located on the HU rear panel. The DC
termination provides a connection point for the power cord which is provided separately with the HU. Use the
following procedure to install the DC power:
1. Locate the 48 VDC power cord which is provided separately with the HU.
2. Place both HU PS module power ON/OFF switches in the OFF position.
3. Connect one end of the power cord to the DC termination on the HU.
4. Connect the other end of the power cord to the 48VDC source.
5. Dress and secure cable per standard industry practice.
Figure 27 48VDC Host Power Connection
4.3.2.5 Local OMC Computer Connection
The primary communication interface between the mBSC system OMC and a local computer is provided by
a single RJ45 jack on the front panel of Host Unit (note: the USB port of the RCU card can also be used to
access the local OMC port). All the connected Remote Nodes can be monitored at the Host Unit side
through the fiber connection. The communication connector supports an IP interface. A CAT5 cable is used