User's Manual
mBSC DAS System
Installation Manual Issue 3
©2009‐2011,BTIPage9
2 INTRODUCTION
This document provides the installation procedures for the BTI DAS system consisting of the DAS Host
Unit, Remote Unit equipment and the Network Management System (NMS). It also provides for the initial
configuration set-up, operation procedures and the software upgrade installation process for the Network
Management System.
For Host Unit and Remote Unit installation, the reader should be familiar with the use of Distributed
Antenna Systems, power system distribution for both AC and DC, all safety guidelines and regulations,
and the required tools to accomplish the installation in a safe manner.
NOTE: This equipment has been tested and found to comply with the limits for a Class A digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference when the equipment is operated in a commercial environment.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and
used in accordance with the instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential area is likely to cause harmful
interference in which case the user will be required to correct the interference at his own expense.
For NMS software installation and configuration as well as firmware update and software upgrade
installations, the reader should be familiar with server administration, software install, firmware update,
and software upgrade procedures at the administrator level.
3 GENERAL DESCRIPTION
Figure 3-1. BTI DAS System
The system consists of an Indoor HU (Host Unit) and an Outdoor RU (Remote Unit) and Network
Management Software.
3.1 SYSTEM COMPONENTS DESCRIPTION