User's Manual
mBSC DAS System
Installation Manual Issue 3
©2009‐2011,BTIPage75
Figure 5-10. Configured Host Unit
5.2.3 Configuring the Host Unit Hardware Card
Once the Host Unit has been added to the system, the IP address for the Host Unit must be changed
from the default to the designated network IP address in the Host Unit Hardware Card. Configuring the IP
Address is done from the Main Command Screen. The following procedures outline the steps necessary
to change the Host Unit IP Address:
1. From the Main Command Screen, Select the added HU.
2. Select the RCU Module, Figure 5-11.
3. Select Config.