User's Manual
mBSC DAS System
Installation Manual Issue 3
©2009‐2011,BTIPage50
NMS ACCESSORY Quantity Received
AC POWER CABLE 1
The following is a list of tools and any additional materials required for NMS software installation:
•
Laptop, Desktop PC and/or Terminal
•
Crossover Cable
•
Hub and/or Router
4.4.3 Unpacking And Inspection
This section provides the instructions for receiving the equipment shipment and verifying that no damage
has occurred during shipping. The NMS software is pre-installed on the server which is shipped with the
following:
•
Optional cabinet with NMS server and Host Unit installed as shown in Figure 4-27.
•
Installation cables and accessories as described in Table 4-12, Section 4.4.2.
Use the following procedure to unpack and inspect the NMS server and accessories:
1. Open the shipping packet and carefully unpack the cabinet from the protective packing material.
2. Verify receipt of accessories using Table 4-12
3. Check the server for visual damage. If there is any damage, contact BTI (Section 6) for further
instructions including an RMA, if necessary.
Figure 4-27. NMS Server
4.4.4 Verify Server software