User's Manual
mBSC DAS System
Installation Manual Issue 3
©2009‐2011,BTIPage33
4. Connect the antenna cable to the antenna port labeled with “ANT”, Figure 4-10.
Figure 4-10. DIN Female Connector
4.2.5.6 AC Power Cable Connection
Danger: Use extreme caution when working with high voltage AC power. Ensure all power
is disconnected before working on power circuit.
Warning: Verify that the Unit has been ground with an earth-bonding cable to the grounding
connector.
Use the following procedure to install the AC Power cable:
1. Route the power cable between the AC power port, located on the bottom of the enclosure and the
nearest AC power junction box as shown Figure 4-11.
Figure 4-11. Junction Box AC Power Cable Routing