User's Manual
mBSC DAS System
Installation Manual Issue 3
©2009‐2011,BTIPage24
•
Wire cutters
•
Wire Stripper
•
Open End Wrench 1.25 inch/33mm (used for DIN connector)
•
Hex Wrench 5mm (M6 screw)
•
SAE Wrench 5/16 inch/8mm (the Slave Remote Unit connectors)
4.2.3 Unpacking And Inspection
This section provides the instruction for receiving the equipment shipment, verifying all parts have been
received and checking that no damage has occurred during transportation. The Remote Unit includes the
following items:
•
Remote Unit(s)
•
Hardware and Fasteners described in Table 4-2, Section 4.2.2
Use the following procedure to unpack and inspect the Remote Unit and accessories:
1. Open the shipping packet and carefully unpack the Remote Unit(s) and any accessories from the
protective packing material.
2. Verify receipt of hardware and fasteners using Table 4-2
3. Check each Remote Unit and accessories for broken or missing parts. If there is any damage or
missing parts, contact BTI (Section 6) for an RMA and to reorder parts, if any replacement parts are
required.
NOTE: Check particularly for any damage to the power connection, the fins/fans,
and the fiber optic cable connection on the Remote Unit Interface.