User's Manual
Table Of Contents
- 1 GENERAL INFORMATION
- 2 INTRODUCTION
- 3 GENERAL DESCRIPTION
- 4 INSTALLATION
- 4.1 SYSTEM INSTALLATION OVERVIEW
- 4.2 REMOTE UNIT INSTALLATION
- 4.3 HOST UNIT INSTALLATION
- 4.4 NMS INSTALLATION
- 5 mBSC DAS SYSTEM START-UP
- 6 Maintenance
- 7 CUSTOMER SERVICE CONTACT INFORMATION
mBSC-H DAS System
Installation Manual Issue 7
© 2009-2014, BTI Wireless Page 27
Figure 4-9. Secure Enclosure To the Side Mounting Bracket
4.2.4.4 Install The Shroud Cover
The Remote Unit has a Shroud cover for thermal protection.
Use the following procedure to install the Shroud cover on the enclosure:
1. Line up the slots at the top of the Shroud cover to the tabs at the top of the mounting panel as shown in
Figure 4-10.
2. Gently lower the slots over the tabs and slide the cover down. The cover will be at an angle, Figure
4-11.
3. Lay the cover flush against the mounting bracket, then carefully, place the M5 screw through the middle
hole, aligning it to the hole on the bracket. Loosely fasten the screw. Working on the opposite side,
again place an M5 screw through the middle hole and loosely fasten the screw.
4. Loosely fasten the remaining M5 screws to all four corners of the cover and then tighten all the screws
securely.