User's Manual
Table Of Contents
- 1 GENERAL INFORMATION
- 2 INTRODUCTION
- 3 GENERAL DESCRIPTION
- 4 INSTALLATION
- 4.1 SYSTEM INSTALLATION OVERVIEW
- 4.2 REMOTE UNIT INSTALLATION
- 4.3 HOST UNIT INSTALLATION
- 4.4 NMS INSTALLATION
- 5 mBSC DAS SYSTEM START-UP
- 6 Maintenance
- 7 CUSTOMER SERVICE CONTACT INFORMATION
mBSC-H DAS System
Installation Manual Issue 7
© 2009-2014, BTI Wireless Page 26
Figure 4-7. The Mounting Panel secured tightly to a Pole
4.2.4.3 Install The Remote Unit On The Mounting Panel
Use the following procedure to install the RU on the mounting Panel.
1. Verify that the attached side mounting brackets, as shown in Figure 4-8 are secure.
2. Grasp the Remote Unit at the top and bottom of the casing and carefully slide the top two hooks onto
the mounting panel, Figure 4-9, followed by the lower hooks and allow the Unit to slide down into place.
3. After hanging the enclosure on the mounting panel, use the M8 screws, lock and flat washers to secure
the rear mounting bracket (top and bottom) so the RU does not move.
Figure 4-8. The Side Mounting Bracket to the Mounting Panel