Users Manual Part 2

CP880+CR650
58
5.6.3 IPv6 LAN Settings
In this page, user can choose the Auto Configuration Type. As shown in Figure 5-60.
Figure 5-60
5.7 System
5.7.1 Maintenance
Reboot
This function enables you to restart the CPE. Settings take effect only after the CPE restarts. To
restart the CPE, perform the following steps:
1. Choose System>Maintenance.
2. Click Reboot. As shown in Figure 5-61.
The CPE then restarts.
Figure 5-61
Reset
This function enables you to restore the CPE to its default settings.
To restore the CPE, perform the following steps:
1. Choose System>Maintenance.
2. Click Factory Reset. As shown in Figure 5-62.
The CPE is then restored to its default settings.