Users Manual Part 2

CP880+CR650
47
Figure 0-38
5.4.3 IP Filtering
Data is filtered by IP address. This page enables you to configure the IP address filtering rules.
Enabling IP Filtering
To enable IP Filtering, perform the following steps:
1. Choose Firewall>IP Filtering.
2. Set IP Filtering Enable.
3.
Click Submit. As shown in Figure 5-39.
Figure 0-39
Disabling IP Filtering
To disable IP Filtering, perform the following steps:
1. Choose Firewall>IP Filtering.
2. Set IP Filtering Disable.
3. Click Submit. As shown in Figure 5-40.
Figure 0-340
Setting Allow access network outside the rules
To set allow access network, perform the following steps:
1. Choose Firewall>IP Filtering.
2. Set Allow access network outside the rules.