Users Manual Part 2

CP880+CR650
44
2. Choose Enable or Disable to modify the configuration.
3. Click Submit. As shown in Figure 5-31.
Figure 5-31
If you choose enable the firewall, you can modify the configuration about firewall, such as Mac
filter, IP filter, URL filter and so on. If you choose disable, you can’t modify any configurations
about the firewall.
5.4.2 MAC Filtering
This page enables you to configure the MAC address filtering rules.
Enabling MAC Filter
To enable MAC address filter, perform the following steps:
1. Choose Firewall>MAC Filtering
2. Set MAC filtering to Enable.
3. Click Submit. As shown in Figure 5-32.
Figure 0-32
Disabling MAC Filter
To disable MAC address filter, perform the following steps:
1. Choose Firewall>MAC Filtering
2. Set MAC filtering to Disable.
3. Click Submit. As shown in Figure 5-33.