Users Manual Part 2

CP880+CR650
39
A maximum of 32 clients can connect to the CPE.
4. Set Hide SSID broadcast to Enable.
If the SSID is hidden, the client cannot detect the CPE's Wi-Fi information.
5. Set AP isolation to Enable.
The clients can connect to the CPE but cannot communicate with each other.
6. Set
Security
.
If
Security
is set to NONE (not recommended), Wi-Fi clients directly connect to the CPE.
This Firewall level is low.
If
Security
is set to WEP, Wi-Fi clients connect to the CPE in web-based encryption
mode.
If
Security
is set to WPA-PSK, Wi-Fi clients connect to the CPE in WPA-PSK encryption
mode.
If
Security
is set to WPA2-PSK, Wi-Fi clients connect to the CPE in WPA2-PSK
encryption mode. This mode is recommended because it has a high Firewall level.
If
Security
is set to WPA-PSK & WPA2-PSK, Wi-Fi clients connect to the CPE in
WPA-PSK&WPA2-PSK encryption mode.
7. Set the encryption mode.
If… Sets to Description
WEP Authentication mode  Shared authentication: The client
connects to the CPE in shared
authentication mode.
 Open authentication: The client connects
to the CPE in open authentication mode.
 Both: The client connects to the CPE in
shared or open authentication mode.
Encryption password
length
 128bit: Only 13 ASCII characters or 26 hex
characters can be entered in the Key 1 to
Key 4 boxes.
 64bit: Only 5 ASCII characters or 10 hex
characters can be entered in the Key 1 to
Key 4 boxes.
Current
password index
This value can be set to 1, 2, 3, or 4. After a key
index is selected, the corresponding key takes
effect.
WPA-PSK WPA-PSK Only 8 to 63 ASCII characters or 8 to 64 hex
characters can be entered.
WPA encryption This value can be set to TKIP+AES, AES, or
TKIP.
WPA2-PSK(reco
mmended)
WPA-PSK Only 8 to 63 ASCII characters or 8 to 64 hex
characters can be entered.
WPA encryption This value can be set to TKIP+AES, AES, or
TKIP.
WPA-PSK &
WPA2-PSK
WPA-PSK Only 8 to 63 ASCII characters or 8 to 64 hex
characters can be entered.