Users Manual Part 2

CP880+CR650
35
Figure 5-17
5.2.9 DMZ Settings
If the demilitarized zone (DMZ) is enabled, the packets sent from the WAN are directly sent to a
specified IP address on the LAN before being discarded by the firewall.
To set DMZ, perform the following steps:
1. Choose Network > DMZ Settings.
2. Set DMZ to Enable.
3. (Optional) Set ICMP Redirect to Enable.
4. Set Host address.
This IP address must be different from the IP address set on the LAN Host
Settings page, but they must be on the same network segment.
5. Click Submit. As shown in Figure 5-18.
Figure 5-18
5.2.10 Static Route
Add Static Route
To add a static route, perform the following steps:
1. Choose Network Setting>Static Route.
2. Click Add list.
3. Set the Dest IP address and Subnet mask.
4. Select an Interface from the drop-down list.
5. If you select LAN as the interface, you need set a Gateway.