Users Manual Part 2

CP880+CR650
30
3. In the PCI Lock area, you can set EARFCN and PCI of the cell, then click Add to add it to
the PCI lock list.
4. Click Submit. As shown in Figure 5-11.
Figure 5-11
5.2.4 APN Management
To set and manage APN, perform the following steps:
1. Choose Network>APN Management.
2. In the APN Management area, you can set the APN.
3. Choose an APN number which you want to set, there are 4 APNs selected.
4. In the APN Setting area you can set the APN parameters, such as enable or disable the APN,
APN name, profile name.
5. Set the authentication type (chap or pap or none) and the username, password of it.
6. Set the PDN type: IPv4 or IPv6 or IPv4/v6 dual stack.
7. Click Submit. As shown in Figure 5-12.
If you want set an APN as default gateway, you should check that is enabled.
And we can also set the APN apply to SNMP or TR069.
Figure 5-12