CP880+CR650 CP880+CR650 User Manual
CP880+CR650 Index CHAPTER 1: Introduction .................................................................................................................. 4 1 Introduction to Outdoor CPE with Router.............................................................................. 4 2 Application Diagram ............................................................................................................... 4 CHAPTER 2: Product Overview ...................................................................
CP880+CR650 5.6 IPv6 ............................................................................................................................ 57 5.7 System ....................................................................................................................... 58 FAQs ................................................................................................................................................ 71 FCC Regulations:............................................................
CP880+CR650 CHAPTER 1: Introduction 1 Introduction to Outdoor CPE with Router Congratulations on your purchase of the CP880+CR650 (Outdoor 4G/LTE Router). It includes two parts, an indoor unit and an outdoor unit. ODU can provide strong accessibility to the LTE network, and has been designed to meet industrial-grade IP67 dustproof and waterproof standard. Router is a wireless device which can provide ODU power supply. ODU with Router in combination is the ideal solution for residential LTE network.
CP880+CR650 CHAPTER 2: Product Overview 1 Important Note for Using This Router 1, Do not remove, open or repair the case yourself. Contact with your Internet Service Provider or have it repaired at a qualified service center. 2, Do not plug and unplug SIM card when device is power on. 3, It is mandatory to earth ground the CP880+CR650. Improper grounding not only could damage the unit but also all equipments connected to it.
CP880+CR650 3 Device Description 3.1 Panel of router Router LED indicator operation 3.
CP880+CR650 7
CP880+CR650 CHAPTER 3: Hardware Installation Please make sure that you are familiar with all accident prevention and Safety procedures necessary for working at height and with electricity before start to install the device. DO NOT install the ODU during a lightning storm. 1 Install SIM Cards Step1 Use a cross screwdriver to remove the SIM card cover. Step2 Slide the SIM cards into the SIM card slots until they click into place.
CP880+CR650 Step 1 CAT5e cable to thread through the cable glands. Step 2 Connect the end of the CAT5e Ethernet cable to the PoE port of the ODU. Step 3 Wring the cable glands into ODU and seal tightly. Make sure you have inserted the SIM card into the ODU. 3 Mount the ODU See the installation instructions to mount the ODU correctly 3.1 Cable glands Connection Cable glands are tools which are vital when terminating cables in harsh or hazardous settings.
CP880+CR650 Step 3: 3.1: Insert B at the back end of C 3.2: keep B close to C 3.3: then tighten A 1, Care must be taken to prevent damage to the entry threads when organizing and installing cable glands 2, Don’t install cable glands while the circuits are live. 3, Cable gland parts aren’t well-matched with those of any other manufacturer of cable gland. 4, Take note that a cable gland isn’t a user-serviceable item. 5, Cable gland sealing rings are added in the cable gland if dispatched from the factory.
CP880+CR650 3.3 Wall or Pole Mounting Mounting on Wall (The built-in antenna is not recommended for wall hanging type, preferred to use Pole mounting method, it can be convenient to adjust the direction of the antenna.) When the ODU terminal is hanging on the wall, the specific mounting as follows: When install ODU on the wall, fixed four screws spacing is 68mm on wall, then the terminal equipment aligns the screws. Hang up and complete the installation.
CP880+CR650 4 Choose Location The ODU can be mounted on an antenna pole or mast or on a wall using the supplied mounting bracket. Choose a mounting point that is sturdy enough to hold the ODU, even during high winds. When choosing a location to install the ODU, please be noted that the ODU’s front panel should point towards your service provider’s nearest base station. You do not need to be able to see the base station from the ODU’s position.
CP880+CR650 5 Connect the Router Place a CAT5e Ethernet cable (not included) from the location of your intended Router to the desired PC location. If you intend to use cable clamps or other methods to secure the cable, do not tighten them until you nish installing the Router and ODU.
CP880+CR650 CHAPTER 4: Software Features 1 Getting Started 1.1 Welcome to the CPE In this document, the LTE (Long Term Evolution) CPE (customer premises equipment) will be replaced by the CPE. Carefully read the following safety symbols to help you use your CPE safely and correctly: Additional information Optional methods or shortcuts for an action Potential problems or conventions that need to be specified 1.
CP880+CR650 1.3 Login the Web Management Page Launch web browser to login the web management page to configure and manage the CPE. The following procedure describes how to use a computer running Windows XP and Internet Explorer 7.0 to log in to the web management page of the CPE. 1. Connect the CPE properly. 2. Launch Internet Explorer, enter http://192.168.1.1 in the address bar, and press Enter. As shown in Figure 1-1. Figure 0-1 3. Enter the user name and password, and click Log In. 4.
CP880+CR650 To ensure your data safety, it is recommended that you turn on the firewall, and conserve your login and FTP password carefully.
CP880+CR650 2 Overview 2.1 Viewing Current Connection To view the current connection, perform the following steps: 1. Choose Overview; 2. In the Current Connection area, view the connection status, such as DL/UL Data Rate and Online time. As shown in Figure 2-1. Figure 0-3 2.2 Viewing WLAN Status To view the WLAN status, perform the following steps: 1. Choose Overview; 2. In the WLAN Status area, view the information about WLAN status, Band, Chanel NO. and Mode. As shown in Figure 2-2.
CP880+CR650 2.3 Viewing LTE Status To view the LTE network status, perform the following steps: 1. Choose Overview; 2. In the LTE Status area, view the information about Connect status, Mode, Cell ID, Signal quality and so on. As shown in Figure 2-3. Figure 0-3 2.4 Viewing WAN Status To view the WAN status, perform the following steps: 1. Choose Overview; 2. In the WAN Status area, view the information about Connect Mode, IP, Subnet Mask, DNS Server and so on. As shown in Figure 2-4.
CP880+CR650 3 Statistics 3.1 Viewing CPU Usage To view the CPU usage, perform the following steps: 1. Choose Statistics; 2. In the CPU Usage area, view the CPU usage information, such as Current CPU usage, Max CPU usage, Min CPU usage. As shown in Figure 3-1. Figure 3-1 3.2 Viewing Memory Usage To view the memory usage, perform the following steps: 1. Choose Statistics; 2.
