User's Manual

Upload Configuration File
You can upload a backed up configuration file to restore the CPE. To do so:
1. Choose System>Maintenance.
2. Click Browse on the Maintenance page.
3. In the displayed dialog box, select the backed up configuration file.
4. Click Open.
5. The dialog box choses. In the box to be right of Configuration file, the save path and name
of the backed up configuration file are displayed.
6. Click Upload. As shown in Figure 5-62.
The CPE uploads the backed up configuration file. The CPE then automatically restarts.
Figure 5-62
5.8.2 TR069
TR-069 is a standard for communication between CPEs and the auto-configuration server (ACS). If
your service provider uses the TR069 automatic service provision function, the ACS automatically
provides the CPE parameters. If you set the ACS parameters on both the CPE and ACS, the network
parameters on the CPE are automatically set using the TR-069 function, and you do not need to set
other parameters on the CPE.
To configure the CPE to implement the TR-069 function, perform the following steps:
1. Choose System>TR069.
2. Set acs URL source. There are two methods, such as URL and DHCP.
3. In the ACS URL box, enter the ACS URL address.
4. Enter ACS user name and password for the CPE authentication.
To use the CPE to access the ACS, you must provide a user name and
password for authentication. The user name and the password must be the
same as those defined on the ACS.
5. If you set Periodic inform to Enable, set Periodic inform interval.
6. Set connection request user name and password.
7. Click Submit. As shown in Figure 7-5.