User's Manual

IP Filtering
Data is filtered by IP address. This page enables you to configure the IP address filtering rules.
Enabling IP Filtering
To enable IP Filtering, perform the following steps:
1. Choose Firewall>IP Filtering.
2. Set IP Filtering Enable.
3. Click Submit. As shown in Figure 5-38.
Figure 5-39
Disabling IP Filtering
To disable IP Filtering, perform the following steps:
1. Choose Firewall>IP Filtering.
2. Set IP Filtering Disable.
3. Click Submit. As shown in Figure 5-39.
Figure 5-310
Setting Allow access network outside the rules
To set allow access network, perform the following steps:
1. Choose Firewall>IP Filtering.
2. Set Allow access network outside the rules.
3. Click Submit. As shown in Figure 5-40.