Installation Instructions

ITEM HT4105
4. INSTALLATION IF NOT USING BTI AQUA-SOLUTIONS FILTRATION FAUCET
Screw 3/8” x 1/4” cold-inlet adapter onto blue
cold-water inlet (A) on top of Dispenser.
Screw 3/8” x 5/16” hot-outlet adapter onto red hot-water
outlet (B) on top of Dispenser.
Make sure larger 5/16” adapter is put onto the red
hot-water outlet (B) on top of Dispenser.
BEFORE the Instant Hot Water Dispenser is plugged into the power outlet, it must be lled with water and checked for tightness
and leaks. FOLLOW THIS PROCEDURE BEFORE CONNECTING DIGITAL INSTANT HOT WATER DISPENSER TO POWER.
1. Open all water valves to allow water to ow to the Filtration Faucet.
2. Turn the “spring-back handle” of any BTI Aqua-Solutions Hot Only or Hot & Cold Faucet (or equivalent) to the open
position and hold until the Dispenser is full and water ows through the faucet spout.
3. Release and close the “spring-back handle” and check all connections for water tightness and leaks.
4. Correct any leaking joints and re-test for water-tightness and leaks before connecting to power outlet.
5. Ensure the installation area is dry and no water is present.
6. Connect the plug to the power outlet and turn on the power outlet at the switch or breaker box.
7. The Digital Instant Hot Water Dispenser display panel will now light up with the On/Off button in the center illuminated.
IMPORTANT!
Connect cold-water line to BLUE cold-water inlet tting.
Connect hot-water line to RED hot-water outlet tting.
Push lines securely into ttings.
Turn water supply back on.
4a 4b
5