Installation Instructions

HOW A VENTED FAUCET WORKS
Water ows from supply line (A) into the faucet base (B).
Water is then diverted inside the faucet into line (C) and into the Digital
Instant Hot Water Dispenser (D).
The fresh water displaces hot water in the Dispenser, causing it to ow
freely through line (E) to the ltration faucet.
Hot water continues straight through the ltration faucet and exits
the spout, (F).
A
IMPORTANT!
NEVER OPERATE THE FAUCET IF THE CLEAR OUTLET TUBE (E) IS KINKED!
NEVER CONNECT AN INSTANT HOT WATER DISPENSER DIRECTLY TO A
STANDARD FAUCET. CONNECTION TO A FAUCET OTHER THAN A 3-LINE
VENTED FAUCET CAN CAUSE INJURY, INTERNAL DAMAGE TO DISPENSER
AND WILL VOID 5-YEAR WARRANTY.
ITEM HT4105
OUTLETINLET
OUTLETINLET
OUTLETINLET
D
B
C
E
F
1. FOR FLOOR-MOUNT INSTALLATION - CHOOSE LOCATION FOR DISPENSER
Find a location under the sink that has access to an
electrical outlet and is close enough to connect the
faucet lines without kinking them. For the unit to oper-
ate properly, it cannot be installed beyond the reach of
the manufacturer-provided electrical cord. Leave 1-2”
clearance around the Dispenser for air ow.
WARNING!
DO NOT PLUG IN THE INSTANT HOT WATER DISPENSER UNTIL IT IS FILLED WITH WATER.
HEATING THE DISPENSER WHILE EMPTY WILL DAMAGE THE UNIT AND VOID THE 5-YEAR WARRANTY.
INSTANT HOT WATER DISPENSER INSTALLATION PROCEDURE
Q
CABINET WALL
HOT TANK UNIT
(SIDE VIEW)
12”
2. 3. 4.
V
R
S
U
T
Slide nut (R) onto
center Hot Tank tube
(S), threads up. Slide
on tapered collar (T).
Slide on 2 orange
O-rings (U). Position
stack of components on tube so that
O-rings are even with top tube. Hold nut
in place and thread connector body (V)
onto nut until snug.
Install hanging bracket (Q) to
cabinet wall. Make sure top
edge of bracket is at least 12”
from bottom of cabinet.
Mount tank on hanging
bracket as shown.
INSTALL BRACKET
MOUNT TANK
CONNECTOR INSTALLATION
2. CABINET-SIDE MOUNT
If mounting on side of cabinet,
install 2 screws into cabinet side that align with the
mounting holes on the back of the Dispenser.
Leave 1”-2” clearance around Dispenser for air ow.
3