Installation Instructions

SAFETY INSTRUCTIONS - READ BEFORE YOU START
These instructions are only intended as a guide. If there is any doubt about installation,
please contact a licensed/certied plumber and/or electrician.
•
•
•
•
•
•
ENSURE THE DIGITAL INSTANT HOT WATER DISPENSER IS NOT CONNECTED TO ELECTRIC POWER DURING THE INSTALLATION.
Using an ungrounded or improper connection of the power supply to the product can cause serious injury or death from
electrical shock. ALWAYS use the USA IEC Power Cord supplied with the unit.
The Digital Instant Hot Water Dispenser must be mounted vertically and level. Because the Digital Instant Hot Water Dispenser is
not under pressure, there is a slight delay in water ow after the Hot & Cold or Hot Only Filtration Faucet handle is turned on. This
is normal and indicates the Digital Instant Hot Water Dispenser is functioning properly.
It is recommended that a “handle spring-back” type Filtration Faucet, like the BTI Aqua-Solutions 2100, 2200 or 2400 Series
Filtration Faucets, is used with the Digital Instant Hot Water Dispenser to protect the user from continuous dispensing of hot
water and possible injury from same.
Place the Digital Instant Hot Water Dispenser in position, check and ensure that the ltration faucet hoses and the power cord to
the electrical outlet will reach without being stretched.
The Digital Instant Hot Water Dispenser must be positioned so the hoses to and from the Filtration Faucet do not twist or kink.
ELECTRICAL REQUIREMENTS
•
•
•
A 110V electrical power supply is required.
It is recommended that a separate circuit serving only the Digital Instant Hot Water Dispenser be provided OR use an outlet that
can be turned On/Off by a switch.
The Digital Instant Hot Water Dispenser is equipped with a power supply cord with a power plug. To minimize possible shock
hazard, the cord must be plugged into a mating ground-type outlet, grounded in accordance with all local codes and ordinances.
PLUMBING REQUIREMENTS
•
•
•
•
If local codes permit, the Hot & Cold or Hot Only Filtration Faucet hoses should be connected to hot and cold water supply lines
using shut-off valves.
The use of ltered, clean water with impurities removed is advised. Place a point-of-use ltration unit such as the BTI
Aqua-Solutions FL1000 in-line PRIOR to the Filtration Faucet.
Unltered water with impurities, grains of sand, etc., can clog the Dispenser and Filtration Faucet and cause the Dispenser’s
5-year warranty to be voided.
Connecting a standard, pressurized faucet may cause injury and will damage the electronic components of the Digital Instant Hot
Water Dispenser and void the 5-year warranty.
ENVIRONMENT REQUIREMENTS
•
•
DO NOT install the Instant Hot Water Dispenser outdoors or in a location where the temperature may fall below 32ºF.
The installation environment should be ventilated, with protection from direct sunlight, in a humidity range of 10-70%.
ITEM HT4105
2