Installation Instructions

【Automatically Share Location】
【TX Time Limit】
【TX Hold Time】
【PTT Follow】
【Tail Elimination】
【Audio Relay 】
【Microphone Gain】
【Wireless Mic Gain】
【Headphone Mode】
【Keep Headset Connected】
【Tone】
【Power Saving Mode】
【Automatic Shut- Down】
【Reset Setting】
【Factory Data Reset】:
:Select the channel
used to send the location report
:Set the time limit for device transmit
:When connect to the repeater, the
lag time for the end of transmission
:PTT follows the current signal channel
:Automatically eliminate the
noise after the end of transmission
:Replay and transmit the received
voice after the end (recording time is up to 30 seconds)
------------------------------------------------------
:Set the microphone gain of the
wired microphone.
:Set the microphone gain of the
wireless microphone.
:Set the access mode of the
headphone system (voice mode and phone mode).
:Select the continuous
connection and trigger connection of the headset
-------------------------------------------------------
:Set the operation prompt tone on the device
:Turn on/off the power mode
:Set the time for automatic
shutdown.
---- - - - - - - - -- - - - - - - -- - - - - - - -- - - - - - - - -- - -
:This function only restores
the set menu function without changing the
frequency/channel data stored by the radio.
This function will restore
all the data of the radio to the factory settings.
Please back up data such as frequency and channel
before performing this operation
------------------------------------------- General Setting------------------------------------------