Installation Instructions

Sound Setting
Speaker: ON means the speaker always on,OFF means the speaker always off
AUTO means automatic adaptation, when the earphone is connected, the speaker is silent.
Mic Gain:Adjust the sensitivity of the microphone,there are three level High,Mid,Low for choose.
BT Mic Gain :Adjust the sensitivity of the bluetooth microphone,there are three level High,Mid,Low for
choose.
Keep Connected:Turning on this option means that the connection to the Bluetooth SCO will not be
disconnected, and the startup speed can be increased, but causing the Bluetooth
headset to not be able to play music
Tone:Turn on or off the keyboard beep
Display Setting
Brightness: Adjust the screen brightness, 1 is the lowest, 15 is the highest, the brighter the screen, the more
power consumption.
Screen Timeout:each time the screen turns off after it lights up, NEVER means the screen is always on.
Time Zone: If the time zone is incorrect, please use this menu to manually correct
1，Connect to Bluetooth PTT
pen the [Pairing] in the menu to enter the pairing
state .
Long press the Bluetooth PTT,
After 10 seconds, the connection will be successful. Press PTT, and the transmitter light of the radio will
in red.
2，Connect to Bluetooth speaker mic
pen the [Pairing] in the menu to enter the pairing
state . Turn on
the bluetooth speaker mic, double click the pair key to enter pairing status.The headset icon will be
displayed in the toolbar when pairing is successful.
Turn-on the radio, then press twice OR o
, a 'BEEP' will be heard and red-green light flashing means the radio is now in pairing status
red-green light flashing means the bluetooth PTT is now in pairing status,
Turn-on the radio, then press twice OR o
, a 'BEEP' will be heard and red-green light flashing means the radio is now in pairing status
orange key
orange key
Connect external Bluetooth devices
Tips:No matter what Bluetooth device is connected, the device and the other party
need to enter the pairing state,To view the status of the paired device, please check
the connection management of the APP
Tips:When you connect Bluetooth PTT, you need to connect a Bluetooth headset to get the
microphone so that you can send voice,Each brand of Bluetooth headset enters the
pairing mode differently, please read the headset manual carefully before pairing with
this device.
NOAA
WX Scan:Turn on weather scan, the device will always be in the scan state until it finds the signal
WX Channel: 1,162.550MHz 2,162.400MHz 3,162.475MHz 4,162.425MHz
5,162.450MHz 6, 162.500MHz 7,162.525MHz
WX Alert:Turn on this option, when the weather warning message is received, the device will sound an
alarm,During the alarm state, you can press any key to mute the alarm message, and the alarm
state will be released after 3 minutes
Manually Search for GPS signals
The GPS status of the walkie-talkie is on by default. If you want to search manually, open the GPS status
menu and place it statically perpendicular to the ground for about 1 minute in an open outdoor area. The
GPS status page will display the longitude, latitude, altitude and other information of the current location.
If the displayed time does not match the local time, please switch to the Time Zone menu and select your
corresponding time zone.