Installation Instructions

FM Radio
Press the menu key to enter the menu, turn on the FM radio, and press the up key to scan the available
frequencies up.
Press the button to scan down the available frequencies, press the OK button to exit the radio mode
Signaling
ID:Your Name ID
Send ID: Allow Send Your ID to Your Partner,
Position:Allow sending your current location to partners
Allow Check:Allow your partner to send instructions to check your current location, and your location will
be fedbackto the partner's device.
Send Message: Send text message to partners (Channel 23-Channel30 Prohibit sending data packets )
Call: When the receiving device receives the CALL command, the walkie-talkie will ring, please enter the
ID to be searched
Check:When the receiving device receives the CHECK command, the walkie-talkie will fed back the
current location ,This option requires the receiver ALLOW CHECK to be effective,please enter the
ID to be searched
Nearby People: This option sends the CHECK command at the current frequency, and all walkie-talkies
of the same frequency will feedback their current position after receiving the command.
This option requires the receiver ALLOW CHECK to be effective,
Radio Menu Settings
Radio Setting
Dual-Watch : If active,it will be Watch for two channel,Press the up and down keys to switch between the
main band and sub band ,and press the side key to switch the waiting channel.
Scan: If active,the radio will be in scanning state,and all channels that are allowed to be scanned will be
scan.
Talk Around:On a channel with a offset frequency, if the option is activate, the transmit frequency will be
the same as the receive frequency
Power:Change the output power
Channel Group: Change the Channel Group For Use.
Add A New Frequency
① Add a regular frequency
Create a new frequency list in new Group,press [enter] button to the channel list , press up or down keys to
select channel No. press [edit] button to edit the frequency, Press [edit channel ] Then accroding
Edit frequency and memory settings to set your frquency.
②Add a GMRS frequency
Create a new frequency list in new Group,press [enter] button to the channel list , press up or down keys to
select channel No. press [edit] button to edit the frequency, Press [GMRS Channel] to select the Channel,
Then Press [edit channel ] ,accroding Edit frequency and memory settings to set your frquency.If you
add the GMRS frequency, all the restrictions stipulated by the FCC will take effect, and you can only modify
the parts that are allowed to be modified,If you want to cancel the GMRS channel information, you can
select [Clear Channel],
Squelch Level : Adjust the squelch Level of the received signal, level 0-9, the smaller the number, the
easier it is to receive weak signals.
TX Time Limit:Limit the maximum time of each transmit.
PTT Follow: Turn on this option, when the sub band receives a signal, press PTT to reply within 10 seconds,
you can send directly at the sub band frequency without switching to the main band.
Tail Elimination: Turn on this option, No end tone will be heard between walkie-talkies of the same brand
Audio Relay: Record the received voice and then transmit it, the recording time is up to 30 seconds,Turn
on this feature, you will hear repeated voices, please be cautious.
Tips:GMRS only allows the creation of new channels between channel groups 2-6