User Manual
Table Of Contents
- Part I. Getting started
- Chapter 1. – Getting Started
- Chapter 2. - GMRS Information and FCC Declaration
- Chapter 3. – Basic Shortcuts and Use
- Chapter 4. – Menu Quick Review
- Chapter 5. – Programming
- Chapter 6. – Other Settings
- Toggle from High to Low Power
- Storing an FM Radio Station and Scanning
- Keypad Lock-out
- PTT ID Setting
- DTMF RX Settings
- DTMF TX Settings
- Remote Stun
- Remote Kill
- Remote Revive
- Read More About Remote Commands
- DTMF Receive Settings, Transmit Setting (Call Key)
- 2TONE Receive Settings, Transmit Setting (Call Key)
- 5Tone Receive Settings, Transmit Setting (Call Key)
- Scanning modes
- SKIP Scanning Channels
- Scanning a Frequency Range (VFO Mode)
- Tone Scanning
- Dual, Tri, and Quad Watch (TMR)
- Chapter 7. - Selective calling
- Part III. How-to and setup guides.
- Chapter 8. - Repeaters
- Chapter 9. - Customization
- Appendix A. - Menu definitions
- Appendix B. - Technical specifications
28
VISIT BAOFENGTECH.COM AND MIKLOR.COM FOR DOWNLOADS AND HELP
GMRS-50X1
15. [Enter Menu]+ [1] + [5] : BCL - busy channel lock- out. If you have this turned on the
transmitter will not transmit if a channel is receiving at the time
16. [Enter Menu]+ [1] + [6] : SC-ADD - scan settings. OFF: This removes the channel from
the scan list. ON: This adds the channel to scanning list.
17. [Enter Menu]+ [1] + [7] : SC-REV – Scanning settings. TO: time out scan, after the
stopping on an active signal, scanning will resume after a few seconds. CO: Scanning will
stop on a carrier channel and will resume after the carrier channel stops receiving SE:
Scanning will stop once an active carrier channel is found.
18. [Enter Menu]+ [1] + [8] : OPTSIG – Turn on the optional signaling. OFF the channel or
mode will not use optional signaling DTMF: DTMF signaling required. 2TONE: 2 tone
signaling required. 5TONE: 5 tone signaling required. (PC programming is required to
specify the DTMF, 2Tone, and 5Tone settings)
19. [Enter Menu]+ [1] + [9] : SPMUTE – Squelch settings when combining standard and
optional tones. QT: The squelch will open for just a CTCSS or DCS Receive tone. AND:
This requires both the optional tone settings (Menu 20) and CTCSS/DCS settings to be
received. OR: If a either the DCS/CTCSS or optional signaling is received the squelch will
open
20. [Enter Menu]+ [2] + [0] : PTT-ID - PTT-ID transmit setting. OFF: no ID code sent when
transmitting. BOT: send ID code at Beginning of Transmit. EOT: send ID code at End of
Transmit. BOTH: send ID code at both beginning and end of transmit. (PTTID code