User's Manual Part 1

page
4
section 01
40040005 rev. 000
B. CALIBRATION TOOLS
The MCU™ calibration kit consists of (1) calibration block, (1) 10 lb.
weight, and (1) 15 lb. weight (Figure 1-2).
C. COMPUTER EQUIPMENT AND CART
The computer equipment consists of a computer cart, LCD monitor, CPU, printer, speakers,
isolation transformer, and a wireless hub (Figure 1-3).
III. ASSEMBLY INSTRUCTIONS
Once the MCU™ Station and computer cart have been unpacked, you are ready to start assem-
bling the unit.
A. SETTING UP THE MCU™ STATION
The MCU™ is shipped on casters to provide maximum protection in transit and ease of
installation. The caster assemblies provide adjustable ground clearance. The system is
shipped in the highest position to clear ramps, curbs, and thresholds, but it can also be
lowered to pass under low doorways.
Step 1. Move the MCU™ to the location you wish it to be used. Using a 3/4” wrench, lower
each caster a small amount until the MCU™ base is resting on the ground. Once the base
is on the ground, remove the casters (Figure 1-4).
Figure 1-2.
Calibration Tools
LCD Monitor
Computer Cart
Printer
CPU
Speakers
Wireless Hub
Isolation
Transformer
Figure 1-3. Computer Equipment and Cart
Lower the Casters
Remove the Casters
Figure 1-4. Lowering and Removing the Casters