User's Manual

235
Changing the location and orientation of ER accessories
Rotating the Multiplanar Accessory Housing Joint
The Multiplanar Accessory Housing Joint can be rotated in
the sagittal and coronal planes. This allows you to create
task simulations as individualized as your clients’ needs.
Rotating the Multiplanar Accessory Housing Joint in the sagittal plane
Locate the handle furthest from you on the right side of the Multiplanar
Accessory Housing Joint, near its hinge (The handle closest to you was
used to insert and remove accessories).
Grip the handle and turn it in a counterclockwise direction, approximately ¼
turn. This will unlock the hinge portion of the Multiplanar Accessory
Housing Joint.
While still gripping the handle, pull it outto the right.
While maintaining the handle in an unlocked position (do not let go of the
handle), pull the Multiplanar Accessory Housing Joint forward or backward to reach the desired position.
The joint will produce a clicking sound at increments of 22.5 degrees.
To identify the angular position of the Multiplanar Accessory Housing Joint, observe the ruler on its left
side, opposite the location of the handle.
Once the Multiplanar Accessory Housing Joint is at the desired angle, release the handle back into the
locked position and turn it in a clockwise direction until it is firmly secured.
If any difficulty is experienced attaching the ER shelves, check the ends of the shelves to
ensure that the Independent shelf is not attached to the Multiplanar Accessory Housing
Joint, or that the Accessory shelf is attached directly to an ER arm.