User's Manual

275
F.R.O.M. Multi-Level Axial Rotation Reach - Occ
PROCESS
The test subject is instructed to move five rows of pegs from Panel 6 – Zone A (Height Adjusted) to Panel
5 – Zone B. The five rows of pegs in Panel 5 – Zone B are then transferred directly across to Panel 6 –
Zone B. Then, the five rows of pegs in Panel 6 – Zone B are transferred to the five rows in Panel 5 –
Zone A (Height Adjusted). Finally, the five rows of pegs in Panel 5 – Zone A are transferred to the same
rows in Panel 6 – Zone A. This completes one cycle. A total of two cycles are completed for this test.
The transfer process requires the test subject, when going from left to right, to take the peg out of the hole
with the left hand, transfer it to the right hand while the peg is out of the hole, and then place the peg into
the corresponding hole with the right hand. When going from right to left, the transfer process is
reversed. The test subject commences with the lowest level row and then proceeds in order to the
highest-level row.
F.R.O.M. Multi-Level Axial Rotation Reach - Freq
PROCESS
The test subject is instructed to move five rows of pegs from Panel 6 – Zone A (Height Adjusted) to Panel
5 – Zone B. The five rows of pegs in Panel 5 – Zone B are then transferred directly across to Panel 6 –
Zone B. Then, the five rows of pegs in Panel 6 – Zone B are transferred to the five rows in Panel 5 –
Zone A (Height Adjusted). Finally, the five rows of pegs in Panel 5 – Zone A are transferred to the same
rows in Panel 6 – Zone A. This completes one cycle. A total of two cycles are completed for this test.
The transfer process requires the test subject, when going from left to right, to take the peg out of the hole
with the left hand, transfer it to the right hand while the peg is out of the hole, and then place the peg into
the corresponding hole with the right hand. When going from right to left, the transfer process is
reversed. The test subject commences with the lowest level row and then proceeds in order to the
highest-level row. The test subject is advised that a ten second-rest period is provided after the
completion of each two cycles.
Once a test has been added to a client, and Perform test has been selected in the bottom right hand
corner of the page (you can also double click the test name), your test page will appear. Below is an
example of what the typical test page should look like.