Datasheet

ManualsBrandsBTC ManualsDigital CameraPCD 3800

STM32F103xx Pin descriptions

25/84

A4 46 62 96 - PB9 I/O FT PB9 TIM4_CH4

(6)

(7)

I2C1_SDA /

CANTX

D4 - - 97 - PE0 I/O FT PE0 TIM4_ETR

(6)

C4 - - 98 - PE1 I/O FT PE1

E5 47 63 99 36 V

SS_3

F5 48 64 100 1 V

DD_3

1. I = input, O = output, S = supply, HiZ = high impedance.

2. FT = 5 V tolerant.

3. Function availability depends on the chosen device. For devices having reduced peripheral counts, it is always the lower

number of peripheral that is included. For example, if a device has only one SPI and two USARTs, they will be called SPI1

and USART1 & USART2, respectively. Refer to Table 2 on page 8.

4. PC13, PC14 and PC15 are supplied through the power switch, and so their use in output mode is limited: they can be used

only in output 2 MHz mode with a maximum load of 30 pF and only one pin can be put in output mode at a time.

5. Main function after the first backup domain power-up. Later on, it depends on the contents of the Backup registers even

after reset (because these registers are not reset by the main reset). For details on how to manage these IOs, refer to the

Battery backup domain and BKP register description sections in the STM32F10xxx reference manual, available from the

STMicroelectronics website: www.st.com.

6. Available only on devices with a Flash memory density equal or higher than 64 Kbytes.

7. This alternate function can be remapped by software to some other port pins (if available on the used package). For more

details, refer to the Alternate function I/O and debug configuration section in the STM32F10xxx reference manual, available

from the STMicroelectronics website: www.st.com.

8. The pins number 2 and 3 in the VFQFPN36 package, and 5 and 6 in the LQFP48 and LQFP64 packages are configured as

OSC_IN/OSC_OUT after reset, however the functionality of PD0 and PD1 can be remapped by software on these pins. For

the LQFP100 package, PD0 and PD1 are available by default, so there is no need for remapping. For more details, refer to

the Alternate function I/O and debug configuration section in the STM32F10xxx reference manual.

The use of PD0 and PD1 in output mode is limited as they can only be used at 50 MHz in output mode.

Table 3. Pin definitions (continued)

Pins

Pin name

Type

(1)

I / O Level

(2)

Main

function

(3)

(after reset)

Alternate functions

BGA100

LQFP48

LQFP64

LQFP100

VFQFPN36

Default Remap