User`s guide

5
ID Setting
Each channel contains 256 sets ID. This extra ID-recognition function helps to
protect against interference from other RF keyboards in the same environment.
After completing the hardware installation you must power on your PC to
set the ID of the receiver, mouse and keyboard.
The word CONNECT labels the ID button on each unit.
Step 1: Press the ID button on the side of the receiver once.
ID Button
Step 2: Press the ID button on the bottom of the mouse once.
Channel Switch
ID Button
Step 3: Press the ID button on the bottom of the keyboard once.
CH2
CH1
ID Button
Remarks:
1. You must follow the procedure above to set the ID of receiver, mouse and
keyboard. Once the receiver ID button is pressed you have 35 seconds to
complete the entire process, or you will need to begin again.
2. Once the keyboard and receiver are plugged in, the yellow receiver light will
flash. Once the ID is set, it will remain steadily lit..
ID Button of Receiver
ID Button of Mouse
ID Button of Keyboard