User`s guide

3 Hardware Installation

Slide Switch Setting

Step 1: Make sure your PC is switched off.

Step 2:

Ta k e t h e receiver and select channel CH1 or CH2 by using the slide switch

on the side of the receiver. (Remember your selection.)

CH2

CH1

Step 3: Connect the receiver to your PC by plugging in the receiver’s PS/2 mouse

connector into the mouse port of your PC and the PS/2 keyboard

connector into the keyboard port.

Mouse Connector

Keyboard Connector

Step 4: Ta k e t h e keyboard and make sure the batteries on the back are installed

correctly. (Follow the polarity signs in the battery compartment.)

Channel Switch

(-)

Battery 1.5V 2pcs

(+)

ID Button

Back View of Receiver

Channel Switch of Receiver

Bottom View of Keyboard