User's Manual

To change the tournament lock, press the button once to display the cur-
rent status, then press it again within 1 second and the LED will blink the
new status.
Note: The tournament lock button is part of the markers circuit board.
Only use light pressure when pressing the button.
To Enter Programming Mode- The TM-15 must be OFF and the tourna-
ment lock must be off to begin managing the functions. While the TM-15
is off, with the selector switch in the safety (S) position, press and hold the
power button, cycle the selector switch, then release the power button to
enter programming mode. If done correctly the LED will change to a solid
red, which is the firing mode function.
Once in programming mode, with selector switch in the (S) position, each
time the power button is pushed you will cycle to the next Function and
the LED will change to a specific color per the descriptions below.
Function’s current value- To view a function’s current value, advance to
the function you wish to check using the power button. Then simply pull
and release the trigger quickly to view its current value by observing the
number of flashes.
Changing a Function’s Value- Once you have selected the function you wish to
change, move the selector switch to the (F1) position to increase the value or to
the (F2) position to decrease the value. Each time the trigger is pulled it will increase
or decrease the function’s value by one. If the selector switch is in the (F3) position,
a single trigger pull will return a function value to its default setting. Once a func-
tion’s value is changed, move the selector switch to the the (S) safety position.
To check the function’s new value, simply pull and release the trigger once while
the selector is in the safety (S) position and the LED will flash the new value. At this
point, you can select a different function to change or exit programming mode.
Exiting Programming Mode- push and hold the power button, cycle the
selector switch, and then release the power button.
11. Setting Functions
Firing Modes
Firing modes will be indicated by a solid red LED. The default firing mode
is the recreational mode (value 5).
Note: Selector position (0) is used as a Safety in all Modes.
Value 1: Semi-Auto – One shot per trigger pull.
Value 2: PSP – The TM-15 will operate in semi-auto mode for the first 3
safety shots; then if the user maintains at least one pull per a second, the
TM-15 will fire “x” number of shots per pull and release of the trigger as
defined by function 6 (burst shots) at the rate of fire defined by function 2.
No trigger pull within one second of the last pull will reset the mode and the
user must fire three more safety shots to continue burst shots.
BTPAINTBALL.COM
7
Function LED Color Default Value Range
1 Firing Mode Solid Red 5 1-5
2 ROF
(rate-of-fire) Solid Green 11 1-25
3 Dwell Solid Orange 28 1-45
4 BIP
(ball in place) Flashing Red 10 1-40
5 Ramping Point Flashing Green 4 3-9
6 Burst Shots Flashing Orange 3 3-9
Selector Switch Position in Programming Mode
S Cycle to Next Function / Read a Current Value
F1 Increase a Function’s Value
F2 Decrease a Function’s Value
F3 Returns a Function to Factory Default
BT_TM-15_Manual.qxp 6/17/09 5:23 PM Page 7