User's Manual

BTPAINTBALL.COM
4
Eye Function
The TM-15 board is pre-programmed to activate the eye system each
time the marker is powered up. See Section 7 (Break Beam Eyes Oper-
ation) for more details.
Installing a Loader and Paintballs
The TM-15 comes equipped to accept 1.03" (outer dimension) standard-
gravity feed loaders as well as most agitating and force-feed loaders. Fit
the loader directly into the feed elbow. It might be necessary to adjust the
feed elbow clamping screw to your loader.
The TM-15 uses .68 caliber, water-soluble paintballs, readily available at
paintball pro-shops, commercial playing fields, and many sporting goods
stores. The paintballs are fed from the loader through the feed elbow and
into the breech of the marker.
Stock Adjustment
The TM-15 stock can be
adjusted by depressing the
stock adjustment lever.
Adjust the stock’s length by
pulling or pushing on the
back of the stock (Fig. 1.5).
Sight Adjustment
The front and rear sights
can be moved anywhere along the top picatinny rail. They can also be
folded down or completely removed when not being used. To adjust or
remove the sights, loosen the screw on the base of the sight and either
relocate it or remove it.
6. Firing the TM-15
Warning: Always keep your TM-15 pointed in a safe direction! Everyone
within firing range should always use paintball approved eye and face
protection in the presence of live paintball markers.
To turn the TM-15 on, set the selector switch to the (S) safety position, push
and hold the power button for 2 seconds, and the LED light will turn green
and then red and then release the button. Your TM-15 is now powered on
and in the safety position
Firing Your TM-15
• Place the empty loader onto the marker.
• Be sure that it is securely mounted in place.
• Apply the compressed gas, pressurizing the marker.
• Put the paintballs into the loader.
• Remove the barrel plug, sock, or barrel-blocking device.
• Aim the TM-15 in a safe direction.
• Turn the TM-15 on.
• Move the selector switch to the desired firing mode.
• Aim the TM-15 at the target.
• Place your finger on the trigger.
• Pull the trigger with a smooth squeezing motion.
Note: When the game you are playing is over, remember to place the
barrel-blocking device onto your barrel and move the selector to the
safety position.
7. Break Beam Eyes Operation
The TM-15 uses a break beam eye system to determine the absence or
presence of a ball for the purposes of reduced paint breakage and opti-
mum rates of fire. The TM-15 board is pre-programmed to activate the
eye system each time the marker is powered up.
Fig 1.5
BT_TM-15_Manual.qxp 6/17/09 5:23 PM Page 4