User's Manual

BTPAINTBALL.COM
14
to clean the eye sensors. Only use a damp cloth with water.
Regulator
Warning: Do not take the regulator apart; it is not designed to be user
serviceable. Damage to regulator will not be covered under warranty.
15. Storage and Transportation
IMPORTANT: Never carry your TM-15 uncased when not on a playing
field. The non-playing public and law enforcement personnel may not be
able to distinguish between a paintball marker and firearm. For your own
safety and to protect the image of the sport, always carry your TM-15 in
a suitable marker case or in the box in which it was shipped.
• Your TM-15 must be clear of all paint and propellant when not being
used.
• Make sure the TM-15 marker is off. Push the power button and hold for
2 seconds until the LED light changes from red to green.
• Put the barrel blocking device in its place. Make sure the marker is clean.
• Store your TM-15 in a clean, cool, dry place.
• Keep your TM-15 away from unauthorized and unsafe users.
• It may be a good idea to remove the battery when storing your TM-15 to
prevent unauthorized use.
This is not a toy. Misuse may cause serious injury or death. Eye Protection
designed specifically for paintball must be worn by the user and persons
within range. Recommend 18 years of age or older to purchase. Persons
under 18 years of age must have adult supervision.
Your TM-15 must be clear of all paint and any source of propellant during
transportation to and from the playing field. Keep your barrel blocking
device in place. Keep the TM-15 Marker switched off. Protect your TM-15
from excessive heat during transportation.
Observe and obey all local, state and federal laws concerning the trans-
portation of paintball markers. For information concerning any of the laws
in your area, contact your nearby law enforcement agency.
If you must ship your TM-15 for any reason, the box in which you purchased
the marker should be used to protect your marker against rough handling
during transport.
Never ship pressurized gas cylinders!
16. Troubleshooting Guide
Note: If you are experiencing any problems and you are using any
aftermarket parts, it is necessary to re-install the factory parts and
re-test before attempting any troubleshooting, as non-factory after-
market parts are not designed by BT Paintball to work in the TM-15,
and they may be the cause of the problems. Do not contact BT
Paintball until you have returned the TM-15 to factory stock
condition and tested.
BT_TM-15_Manual.qxp 6/17/09 5:23 PM Page 14