User's Manual

BTPAINTBALL.COM
11
TM-15. Do not use any chemicals, as you may damage the protective finish.
If a full cleaning is needed, we recommend that you fully disassemble the
TM-15; doing so will allow you to rinse the shells with hot water to remove
dirt and paint buildup.
Warning: Do not rinse the TM-15 under water without fully disassembling
the marker, as you may damage the markers electronics.
14. Assembly/Disassembly Instructions
CAUTION: Before attempting to perform any marker disassembly, make
sure that all paintballs and propellant sources have been removed from
the marker and that the regulator gauge reads 0 psi. Install a barrel-
blocking device, move the selector switch to the safety (S) position, and
make sure the TM-15 is turned off.
Disassembly Tips
•Make sure you have a clean area to work on your marker.
• Do not remove the air transfer tube from the body and regulator; these
parts are assembled tightly at the factory to prevent leaks.
• When separating the shell for the first time, locate the trigger and trig-
ger spring, notice their position for easy reassembly.
• Make sure the main spring is installed correctly on the bolt, as it needs
to be installed in the right direction.
• After reassembling the TM-15 recheck your trigger activation settings.
Visit PaintballSolutions.com for additional information.
Barrel
It is recommended that the barrel be removed before and other mainte-
nance or disassembly is performed. Simply turn the barrel counter clockwise
to remove. Use warm water and a barrel cleaning device to keep the barrel
in top condition.
Feed Elbow
To remove the feed elbow, push and hold in the latch button while sliding
the feed elbow forward and lift off the elbow when it reaches the narrow
section of the top rail. The Feed elbow does not slide off the front of the rail.
Note: Make sure that when the feed elbow is reinstalled it lines up with
the hole on the right side of the shell.
Magazine
To remove the magazine, press in the magazine release button located on
the right side of the TM-15 and pull the magazine down and out of the shell.
Front and Rear Sights
Using a 7/64" Allen wrench, loosen the screws at the base of both the
front and rear sights, and remove.
Removable Shell Panel
The removable shell panel can be removed to access the internal assem-
bly for basic cleaning and maintenance by removing the two panel
screws with a 7/64" Allen wrench and then lifting the panel off.
Stock Assembly
The stock assembly can be removed from the shell once the removable
shell panel has been removed.
Grips
Using a 5/64" Allen wrench, remove the four 6-32 button head screws holding
the grips in place. Notice that the lower screws are longer than the top grip screws.
Selector Arm
It is not necessary to remove the selector arm when dissembling the
TM-15. Using a 1/16" Allen wrench, remove the flat head screw which
holds the selector arm to the selector shaft.
BT_TM-15_Manual.qxp 6/17/09 5:23 PM Page 11