Installation guide

8
INSTALLATION
7. Now follow the instructions in Part E.
B For Windows 95 Version 4.00.950b
1. Switch on your PC, if you have not already done so, and Windows will
automatically detect the card you have just installed.
2. The ‘New Hardware Found’ screen will be displayed. If this screen is not
displayed, close down Windows, switch off your PC and check that the card
is physically installed correctly.
3. Immediately after the ‘New Hardware Found’ screen is displayed the
‘Update Device Driver’ wizard will be started and it’s initial display shown.
4. Insert the BT Speedway PCI Card CD in your PC’s CD drive.
5. Click Next and wait whilst Windows updates it’s driver database. This will
take a few seconds.
6. Windows will announce that it cannot locate the driver for the recognised
device. Click Other Locations, and you will be prompted to enter a ‘Path’
name.
7. Either type D:\CARDWARE\WINDOWS.95 (where D should be substituted
with the drive letter that represents your CD drive) and click OK
OOrr
click
Browse, in the ‘Drives’ section and select your CD drive drive letter.
Double-click on Cardware which will be shown in the ‘Folders’ section and
double-click on Windows.95.
8. Click OK and click Finish again on the following screen.
Figure 2