User's Manual

BTPAINTBALL.COM

• The green LED will come on for 1 second. If changing the speed

setting, press the power button while the LED is a solid green.

When the LED turns to red the new setting can be entered. Now

press the power button the number of times necessary based on

the new setting. Each time the button is pushed an orange LED

will appear. After the new setting is entered the green LED will

flash the new setting.

• The orange LED will come on for 1 second. If changing the sen-

sitivity level setting, press the power button while the LED is a

solid orange. When the LED turns to red the new setting can be

entered. Now press the power button the number of times nec-

essary based on the new setting. Each time the button is pushed

an orange LED will appear. After the new setting is entered the

orange LED will flash the new setting.

• The Rip-Clip will automatically exit programming mode.

6. RF (Radio Frequency)

RF Installation

The Rip-Clip comes ready to accept an Empire RF Transmitter.

Once a transmitter is installed the Rip-Clip will be ready to receive

an RF signal from your marker.

• Remove the bat-

tery cover and

set aside.

• Carefully plug

the RF transmit-

ter into the Rip-

Clip’s harness

(Fig. 6.1 ).

• Install the RF

Transmitter into

the Rip-Clip’s

body as pic-

tured (Fig. 6.2).

• Make sure the har-

ness wires are not in

the way of the battery

door before re-

installing it.

Using the Rip-Clip in RF

Mode

To use the Loader in RF

mode, an Empire RF

Transmitter or compatible

Fig. 6.1

Fig. 6.2

Rip_Clip_Manual_TM_Series.qxp 1/26/10 3:02 PM Page 7