User's Manual

BTPAINTBALL.COM

5. Board Functions

Programming

There are two functions which can be adjusted in programming

mode. The default settings should be good for your marker.

• Motor Speed– 3 levels of adjustment, level (1) being the slowest

motor speed and level (3) being the fastest.

NNoottee::

It is recommended that you do not set the speed higher than

needed. Using higher speeds than needed will only shorten the life

of your batteries.

• Sound Sensitivity– 3 levels of adjustment, level (1) being the

least sensitive and level (3) being the most sensitive. This setting

is only used in sound activation mode.

NNootteess::

It is better to have the microphone setting less sensitive and

still able to detect the marker firing. Do not set it to 3 if setting 1

detects the marker firing. Only use a higher setting if the lower set-

ting does not detect the marker firing.

Entering Programming Mode

• Make sure the loader is turned off.

• Press the power button, and then quickly release the power but-

ton.

• A solid green LED will appear, while the LED is a solid green,

press the power button one time.

Current Settings

Once in programming mode the loader will display the current

settings.

• The green LED will flash the motor’s current speed setting (1

slowest; 3 fastest).

• The orange LED will flash the current sensitivity setting (1 less

sensitive; 3 most sensitive).

Adjusting Settings

After the Rip-Clip displays the current settings, you can enter the

new setting that you desire.

Functions LED Color Default Value Range

11 MMoottoorr SSppeeeedd SSoolliidd GGrreeeenn 22 11 -- 33

22 SSoouunndd SSeennssiittiivviittyy SSoolliidd OOrraannggee 22 11 -- 33

Rip_Clip_Manual_TM_Series.qxp 1/26/10 3:02 PM Page 6