Unit installation

85
01 Account No.
This number should be unique to each control panel and is used to identify the
site to the monitoring station, Alarm Receiving Centre, Galaxy Gold etc. A
unique account number must be entered before the control panel can dial out –
failure to program an Account number will result in a Comms Fail message
when the panel attempts to dial. The number of digits in the Account number is
dependant on the receiving equipment; it is usually eight for SIA format and
four for DTMF format.
The B key can be used to erase an existing number. The whole number should
be erased before a new one is entered.
02 Telephone Number 1
Telephone Number 1 must be entered if the digi is to be used. This is the main
telephone number that the alarms are signalled to. Up to 16 digits may be
entered, including control modifiers. The control modifiers are entered using the
Ö and # keys:
# – Dial tone detect (wait for new dial tone). This displays as a #. Each dial tone
detect lasts for 15 seconds. If a new dial tone is not detected in this time, then
the dialling attempt is aborted. This is counted as a fail to communicate.
Ö – Pause (for two seconds before dialling the next digit). This displays as a
Ú.
To programme the telephone number:
• Go to the 02= TEL NO.1 menu option.
• Press the ent key.
• Using the number keys on the keypad enter the telephone number,
including any control modifiers.
• The B key can be used to erase an existing number.
Note: The whole number should be erased before a new one is entered.
03 Telephone Number 2
A second telephone number is available to support Dual and Alternative
dialling to a second receiver. The programming is identical to Telephone
Number 1.
04 Format
The communicator provides three formats of signalling, the format selection
will affect both Telephone Number 1 and Telephone Number 2.
1. DTMF (Dual Tone Multiple Frequency)
The DTMF is Fast Format. This format is accommodated by most
Monitoring Stations.
12 = Communications 1 (cont’d)