Unit installation

58
Table 5.6 System Parameters, 7 to 15.
Selecting and Modifying Parameters
When the Parameters option is selected parameter 01 Entry Time is dis-
played, the A and B keys can be used to view the other parameters. When the
required parameter is displayed press the ent key to select it.
On selecting the required parameter, the current setting is displayed. The
parameter is programmed either by entering a value within the allowed range or
pressing the # key to toggle the status of the option, pressing the ent key
saves the selection. To exit the Parameters option or cancel the programming
press the esc key.
Any variations to this procedure are detailed in the description of the param-
eter.
01 Entry Time
This parameter determines the Entry Time allowed to users when unsetting the
system. The default is 120 seconds with a programmable range of 0 to 900
seconds (15 minutes).
Note: The Entry Time programming affects all parts. The Entry Time cannot be
uniquely programmed for individual parts.
02 Exit Time
This parameter determines the time users have to exit the premises or selected
part during timed setting of the system. The default is 120 seconds with a
programmable range of 0 to 900 seconds (15 minutes). Entering a value of 900
seconds sets the exit time to infinity.
Note: The Exit Time programming affects all parts. The Exit Time cannot be
uniquely programmed for individual parts.
6 = Parameters (cont’d)
noitpOuneMnoitceleSnoitceleStluafeD
sretemaraP60
)deunitnoc(
teseR70redurtnI1delbasiD
AP2delbasiD
repmaT3delbasiD
mrifnoC4elbanE
yaleDlleB80s009–0000
tratSdloC90
!atadesol=tne
etomeR01
teseR
nO=0
ffO=1
ffO=0
etomeR11
noisreV
552–0
0
poTrennaB21
erawtfosdnaepytlenaP=knalB
.noisrev
rennaB31
mottoB
.etaddnayad,emiT=knalB
tixEtraP41
emiT
009–0s021
mrifnoC51
emiT
99–0m06