Unit installation

55
Table 5.3 User Code Attributes.
Log Code
A code can be made to log every time it is entered by disabling all the code
attributes. A log code will have access to menu options 2 (Chime) and 3 (Walk).
Every entry of the code will be recorded in the event log.
Codes and Keyswitches
Any zones programmed as Keyswitch must be assigned the attributes of User
1, 2 or 3. The Keyswitch zone then has the Set/Unset and Reset capabilities of
that user code, therefore:
• If the Keyswitch is to be used to set or unset the system it must be
assigned to a code with the Set Access and Unset Access attributes
enabled.
• If the Keyswitch is to be used to perform a Part set or unset it must be
assigned to a code with the appropriate part attributes enabled (Part 1
Access, Part 2 Access and Part 3 Access).
• If the code is to be used to reset alarms it must be assigned to a code with
the Resets attribute programmed accordingly, see 6 – Parameters; 07
Reset
.
The Keyswitch assumes the assigned attributes of the user even if the user has
not been allocated a code (PIN).
For information on assigning a Keyswitch zone to a User Code see Option 7 –
Zones; 4 Keyswitch
.
4 = Codes (cont’d)
.oNetubirttAnoitpircseDtluafeD
1sseccAteStraProteSlluFotresuehtselbanE
.metsysehtteS
.delbanE
2sseccAtesnUtraProtesnUotresuehtselbanE
.metsysehttesnU
.delbanE
3sseccA1traP.1traPtesnu/tesotresuselbanE.delbanE
4sseccA2traP.2traPtesnu/tesotresuselbanE.delbanE
5sseccA3traP.3traPtesnu/tesotresuselbanE.delbanE
6gnittimOelbattimotimootresuselbanE
.senoz
.delbanE
7sedoCyfidoMresUmargorpotresuselbanE
.setubirttadnasedoC
,delbasiDsresU
.delbanE.rgM
8steseR † desirohtuateserotresuselbanE
otrefer,snoitavitcamrala–6noitpO
steseR70;sretemaraP.
.delbanE
† .ylnoedoCreenignEhtiwelbammargorpetubirttasihT