Unit installation

54
Figure 5.9 Deleting a User Code.
Programming Codes Attributes
When the Codes option is selected, USR 1 is displayed, press the A or B keys
to view other users. Press ent to select the required user then press the # key to
access the code attributes— (user instruction only, the engineer cannot carry
out this operation).
The Set Access attribute is displayed along with its status. An attribute is
enabled when the square next to the attribute number is black and ENABLE
appears on the bottom line of the display. To toggle the status of an attribute
press the # key. Press the A, B and # key to view and modify other attributes.
>
ÚÚÚÚ
(0—9999)
USR 1
User Number (range: 1–14)
Valid Code Range
Pressing the
Ö
key four
times deletes the digits in
the assigned code.
>———— (0—9999)
USR 1
Once the code has been cleared press
ent
to
accept the programming or
esc
to cancel.
Currently assigned code hidden.
Figure 5.10 Set Access Statuses.
Note: Pressing the attribute number key, (1 – 8 for the engineer, 1 – 7 for users),
directly toggles the enable status of the corresponding attributes.
When the required attributes have been assigned to the user, press the ent key
to save the selection or esc to cancel.
The display returns to the selected user number. Press the A or B key to view
the other users. To exit from the Codes option press the esc key.
Table 5.3 User Code Attributes lists the available Code Attributes and defaults.
4 = Codes (cont’d)
1
zz
zz
z SET ACCESS
ENABLED
1


 SET ACCESS
#, 1 = ENABLE
# or 1 to toggle
Set Access status
(a) Set Access disabled (b) Set Access enabled