Unit installation

46
Figure 5.2 Direct Menu Access.
Figure 5.1 Entering Engineer Mode.
Menu Access
There are two methods of selecting menu options: Direct Access (using keys 0-
9) and Menu Driven Access (using the ent key followed by the A, B or number
keys).
Direct Access
Pressing a valid option number immediately after entering the code selects that
option for programming without having to enter the menu. If the engineer is in
the menu, entering an option number immediately selects that option. Once the
selected menu option has been programmed, the engineer returns to the
previous level of access (menu or Engineer Mode banner). This is illustrated in
Figure 5.2 Direct Menu Access.
Example: Direct access selection of Option 6, Parameters from the Engineer
Banner.
Menu Access
(a)
Enter Engineer Code
×××
(c)
Enter Engineer Code
×××
ALARM IS ACTIVE
(b)
Keypad goes into alarm
(d)
System alarm message is
displayed
[01] SYSTEM
ENGINEER
(e)
Press esc to go to
Engineer Banner
ENGINEER MODE
18:10 MON 30 JUN
>-- A=SET B=PART
ENT, 01-13=MENU
(f)
Press ent to go to Engineer
Set, Part Set or Menu Screen
(a)
From Engineer Banner
ENGINEER MODE
01:13 FRI 14 JAN
(b)
Enter Engineer Code
×××
(c)
Engineer Set, Part Set
or Menu Screen
>- A=SET B=PART
ENT, 01-13=MENU
01=ENTRY TIME
ENT, 01-14=SELECT
(d)
Press 6 for Direct Access of
Menu Option 6, Parameters