Unit installation

xiii

Quick Setup

To quickly set up a Galaxy 16 or 16 plus these simple steps should be followed.

Note: these steps should not be followed for a first time set up procedure, only

those familiar with the Galaxy 16 and 16 plus control panels should use the

quick set up procedure.

1. Connect a 1kΩ (±1%) resistor across each of the zone terminals on the

Galaxy Control Panel, and the Galaxy RIO or Smart Power Supply (if fitted).

2. Ensure that the tamper reyurn loop, the terminal marked as T on the control

panel PCB is chorted to 0 V at one of the terminals marked as - on the

control panel PCB.

3. Connect a keypad to the line terminals on the control panel PCB. Connect

the terminals as follows:

4. Connect a 680 Ω end-of-line resistor across the A abd B terminals of the

Galaxy keypad.

5. Ensure that the keypad is fitted to the keypad mounting bracket: a keypad

tamper occurs if the tyamper spring is not retained when the system is

powered up.

6. Connect the mains wiring to the control panel - do not switch on the a.c.

mains supply.

7. Replace te control panel enclosure lid and secure the fastening screws.

8. Turn on the a.c. mains supply.

9. The following events occur:

• the Galaxy keypad buzzer and the control panel speaker output activate.

• the Galaxy keypad shows ÜÜÜÜÜÜÜÜ on the LCD display.

• the sounders stop and the keypad display goes blank.

• the green power LED on the Galaxy keypad illuminates.

• the default banner is displayed on the Galaxy keypad.

10. The system is now ready to be programmed, refer to Section 5: Menu

Options for details on the programming of the panel.

BCPlortnoCdapyeKyxalaG

Quick Setup