Installation manual

Windsor Installation Manual - Issue C
-
53
-
Command Modem action Modem
response
2 : ADEMCO Contact ID
9 : ADEMCO Superfast
ATDRxxxx\r Dial telephone number with double call timer enabled.
AT&D3 Program the number of rings on first call attempt when
using the ATDR option (default = 1)
AT&RI 1 - Report double ring burst as a single ring
0 - RI follows the ringing cadence (default)
AT&CD 1 - DCD will follow the state of DTR irrespective of the
carrier
0 - DCD follows the carrier signal (default)
AT&TBR
1 - Enable timed break recall (default)
0 - Disable timed break recall
AT&BD 1- blind dial enabled
0 - blind dial disabled (default)
AT&CC 1 - in half duplex modes, on RTS active, only assert
CTS if the remote carrier is off (DCD is clear)
0 - in half duplex modes, on RTS active, assert CTS
irrespective of DCD status (default)
AT&CH 1- in full duplex, do not hang up if no carrier (used for
approvals only)
0 - in full duplex, normal hang up on no carrier (default)
ATZn Select modem profile where n is;
1 - Windsor 500, Windsor 700 version 8, Windsor
modem Receiver.
2 - Vigil V64 Mk2 panels using V23 mode
3 - Vigil V64 Mk1a panels using V23 mode
ATZnCC As ATZn with the country code added. For example,
ATZ144 would configure the modem for use with
GuardStation in the UK (country code 44).
Result Codes
Verbose Mode Numeric Mode
OK 0
CONNECT SDP (300bps FSK/DTMF) 1
RING 2
NO CARRIER 3
ERROR 4
CONNECT 1200 (V22) 5
NO DIALTONE 6
CONNECT 2400 (V22bis) 10
CONNECT 600 (V22) 11
CONNECT SDS (SmartDial Super or SmartComm) 12
Forbidden Call (numeric only) 103
LINE BLOCKED verbose only
LINE CLEAR verbose only
NO 50V verbose only