Installation manual

Windsor Installation Manual - Issue C
-
44
-
AV60
Access PIN Code
To program the access PIN code;
1. Connect a telephone handset with DTMF capability to the telephone socket of the
AV60.
2. Press #7 on the handset.
3. Enter the 4 digit access code.
4. Press * to terminate the access code.
5. Press #3 to exit.
If the control panel is de-powered the access PIN code must be re-entered.
AV60
Command Functions
All commands from the alarm receiving centre are entered using a DTMF telephone handset.
Code Function Code Function
*0 All channels on *9 Auto sequence all channels
*1 Channel 1 on #1 Replay stored audio
*2 Channel 2 on #2 extend time by 2 minutes
*3 Channel 3 on #3 shut down
*4 Channel 4 on #7 enter passcode
*5 Channel 5 on 00 Talkback
*6 Channel 6 on 01 Broadcast
*7 Channel 7 on 02 Record site message
*8 Channel 8 on 03 Playback site message
AV60
Commissioning
1. Check that the green LED on all microphones is flickering.
2. Set the alarm system. The red LED on all microphones should be on.
3. Cause an alarm.
4. The red LED on the AV60 PCB should be flashing.
5. Wait at least 30 seconds or until the red LED stops flashing and comes on continuously.
6. Dial the AV60 telephone number using a DTMF telephone handset.
7. On connection all sounders should be muted.
8. The AV60 will play back the site message and prompt for the access code.
9. Enter the programmed access code followed by *.
10. The AV60 will either play back the stored audio or switch to live audio.
11. Select each channel using the appropriate command.
12. Enter #3 to shut down the call.